Kawasaki Motorcycle Forums banner

Changed my clip ons and now it won't start?

903 views 1 reply 1 participant last post by  Upland117 
#1 ·
I just changed the clip ons on my 03 zx6r and now the bike just cranks over without firing at all. Everything else seems fine and works except it just won't fire.

The cables are now pretty tight at full turn since the bars are a bit higher, but I have no idea what I would have done to cause it all of a sudden to not start?

Any thoughts? Thanks
 
#2 ·
Well I was able to find what the problem was.

Since I found the bike had no spark and the fuel pump was not working I figured I'd try to find one thing that could effect both that I may have worked on while changing my clip ons. I checked the wiring diagram and found a grey wire going from the ignition switch to the ECU.

Earlier I had checked the bottom of the ignition for loose wires and didn't see any but I checked again and now moved some of the wires finding the grey wire which had broke loose from the solder on the bottom of the ignition switch.

After soldering it back on it the bike fired right up.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top