Kawasaki Motorcycle Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-20 of 48 Results
  1. Ninja 250R
    Hi all, I have a 2008 Ninja 250R with a weird problem. To describe the situation: I turn on the bike with no issues but it slowly starts dying after a couple of seconds. I try to rev it and sure enough it powers off instantly. After this the motorcycle refuses to turn on. After a couple of...
  2. Ninja 250R
    I've been hunting for a confirmed 2012 ninja 250r wiring diagram, it seems to be impossible to find.
  3. Ninja 250R
    Hello guys, my 2012 Ninja 250R FI occasionally starts very rough and idles at less than 2k RPM (when it starts normally it idles at about 3k RPM until it warms up) and I think on only 1 cylinder and the FI light on the dashboard lights up. This only happens in like 1 in 50 cold starts. When it...
  4. Ninja 250R
    Hey everybody. I have a 96 ninja 250 and I’m wondering what the stock compression specs are in PSI. The left side reads 140. And the right reads 110. Also, when it was running it would bog down and lose power between 8k-9.5k then come back one I got past it. I found on another thread here that...
  5. Ninja 250R
    Hi all, i’m new to this forum as i’ve just bought my first bike. This is a red kawasaki ninja 250R from 2009. I bought this bike and it was in good running condition, had the VIN ran, and everything. We returned this bike to my bourse after purchasing it, it rode fine, and we had no issue. The...
  6. chillin in the man cave

    brought her in the living room to work on her, it's cold out.
  7. the ninjette

    right after she got a new growler
  8. My First Bike

    My first bike ever!
  9. First day home

    2009 Ninja 250R with Icon pursuit coat, accelerant gloves, tank bag and Shoei RF1000 and HJC helmet.
  10. Comparing two sprockets

    Another shot of the two sprockets. It's blurry, but the aluminum sprocket was getting pretty sharp!
  11. Comparing two sprockets

    I'm comparing my old 41T aluminum sprocket to a new 41T aluminum hub/steel ring sprocket. Damn aluminum one wore out in less than 6k miles.
  12. Puig wind screen for an '08 250r

    *Title explains it*
  13. Cheapy tank vent for a 2008 250r

    From the blue dot port on a California gas tank I plumbed about 6" of fuel line, threw a cheapy inline fuel filter and a PCV valve (to make sure air will only flow INTO the tank through that line). It's cheap, but works.
1-20 of 48 Results