Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
136 Posts
Discussion Starter #1
Just got a set of vortex adjustables at Mid O for my 06 636. It has 2 shift rods. which one do I use if I want gp shift? Do I need to bend it? On my 01 r6 I had to buy a shift rod from woodcraft that had a kink in it to accomidate.

I saw the thread listed here:
http://www.kawiforums.com/forum/topic.asp?TOPIC_ID=32499

but that dealt with stock rearsets, I would think I'd be able to do it without stacking washers if I have aftermarket rearsets

thanks
 

·
Registered
Joined
·
460 Posts
If I remember right, it was the shorter one. Also check out the How-to section. Damn good write up in there that will answer almost any question you might have.
 

·
Registered
Joined
·
4,279 Posts
you shouldnt have to bend it. that why it came with 2 rods, one for regular shifting and one for gp shifting.
 

·
Registered
Joined
·
136 Posts
Discussion Starter #4
oh, the literature that came with the rearsets said that was just to accomodate different rearset positions, as they are fully adjustable
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top