Kawasaki Motorcycle Forums banner
1 - 1 of 1 Posts

1 Posts
Discussion Starter · #1 ·
Hello to anyone. New here would like to ask a ? Trying to lower front end to 07 zx6. Went 1" down. The fork tubes narrow in on the tube where the clipons are sitting. Due to being narrow the clipons can not tighten down. My question is can you put a spacer (rubber sleeve) on the clipons to allow it to tighten down at this height? Has anyone run into this problem?

07' 650r
07' zx6
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.