Kawasaki Motorcycle Forums banner

1 - 8 of 8 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1 (Edited)
So, I had the honor of working with the president of the company Area P, Kerry Bryant, by allowing them to use my 300 to test fitment on their FIRST (yes, first :D ) production exhaust. Along with that they also ran dyno tunings and mapping to make sure it was running optimally.

As far as my bike this is the run down of what was put onto it;
  • Full carbon fiber high mount shorty exhaust
  • Mounting brackets
  • Rear peg delete
  • Fairing spacers
  • FI Tuner from Fuel Moto
  • Fender eliminator (Targa)
They ran many dyno test while the bike was there, I left it for a week so they put tons of time into making everything perfect with their tuning and mapping. I couldn't be any happier with the results.

Here is the chart, the proof is in the pudding:



As you can see it really shows how the 300 with the stock exhaust peaks at 10750 rpm and starts to drop off quickly from that point on. When they put on the Ultra High Mount system, you can see it continues to build power and then maintains the power all the way to the soft limiter at 12750 rpm. The Area P system all together makes over 7 hp more than stock, after 11500 and above. I must say it is VERY impressive when you are talking about a modification gaining you that much HP. Aside of the peak power though you can clearly see that the Area P system makes power right from the bottom 3000 rpm, all the way to the soft limiter. Area P spend a lot of R&D time to achieve this and I must say they hit the nail RIGHT on the head. The "dip" in the powerband at about 8750 - 9500 is part of the characteristics of the Ultra High Mount system, as explained to me by Kerry Bryant it's what they call a peak power pipe, where it really starts to "hit" at 9500 rpm and pulls all the way to the soft limiter. The quote from Kerry about it was "It lets you "know" that you are really making power through the "seat of your pants" and that you do not need to be looking at a Dyno chart to feel it."

The look is phenomenal; the combination of the carbon fiber, high mount, and everything ties in so well together in my opinion. The high mount really is amazing, on this system especially it tucks in so clean to the bike. Area P really outdid themselves with this one, they seemed to have paid extreme attention to every curve on this bike making the system look as if it was supposed to be there all along. Also, the FI Tuner was placed under my back seat in the near non-existent "trunk" persay :p PERFECT use of this space, Kerry placed it under there and mounted it into place using velcro so it is easily taken off and easily at that if ever desired.

I honestly cannot be ANY happier with this system, in all seriousness. It completely exceeded my expectations! You can instantly feel the difference, it gains so much more than just sound. As far as sound, once again blew me away. It is a very throaty raw sound, deep and crisp. I will be doing a nice sound clip video of riding through the gears and post it up. Until then here are some pictures of my bike and her system and mods;








.









Overall, my experience with Area P & Kerry Bryant really impressed me, not only was Kerry an endless dictionary of useful information and there to answer ANY of my questions but he also made sure to update me and fill me in on everything there could be to know. I would recommend them anyday!
 

·
Premium Member
Joined
·
15,223 Posts
Not a bad gain, How much $$$ ?
 

·
Registered
Joined
·
24 Posts
Discussion Starter #3
Not a bad gain, How much $$$ ?
Well, I got mine for free for allowing them to use my bike for a week.

However, I believe it was in the ballpark of $1300 but that included cost for custom dyno runs, tuning, installation, ect.

You could always contact Kerry at Area P and tell him you spoke with Brittany about the system and have him give you an exact quote.

They only sell full systems, no slips. Kerry stated he will only make something that benefits the bike, slip ons essentially just create sound and drop some weight but when it comes down to it give no performance gain beyond that.

Hope this helps.
:)

I can give you Kerrys email or you can go to the Area P website and use the contact box if you wish, which also goes to him
 

·
Premium Member
Joined
·
15,223 Posts
I was just curious what the cost was. Nice bike BTW, I haven't had the chance to see a 300 in person yet.
 
1 - 8 of 8 Posts
Top