Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
537 Posts
Discussion Starter #1
Got new friction plates in the mail today + new springs. Went for Kawi OEM zx6r vs. 12r springs, should work just fine.
My question is how big of a job is it. I have kawi manual, and it looks pretty easy. Anything I should watch out for?
 

·
Registered
Joined
·
248 Posts
No it's real easy if you are at all inclined to do such work. I did it on my 02' and the whole job took about 45 minutes from start to finish! Just make sure you soak the new fibers for about 40-45 minutes in some fresh oil, and make sure the adjustment is correct when done. Good luck (I think proper break in is 1 healthy burnout followed by a top speed run:D) j/k

John
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top