Kawasaki Motorcycle Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
I have a 2005 zx6r that I stunt ride while riding it I broke my clutch cable Ordered a new clutch cable for it adjusted it found other problems that had caused my cable to actually break went ahead replaces the throw out bearing and clutch release rod so I also replaced my clutch while I was in their now I can go threw the gears but as soon as I give it any power the clutch slips it’s ass of is their a certain way these plates go in maybe I got them mixed up is only thing I can think
 

·
Registered
Joined
·
75 Posts
Did you install the clutch referencing the Manual or from memory ?
The last friction plate gets installed offset to the rest, I can attach the Kawasaki Manual pdf of this section if required..
 
1 - 2 of 2 Posts
Top