Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
94 Posts
Discussion Starter #1
Well, it was a good day until.

Long story short:

Nice weather...got to ride.....came home and my title was in the mail and UPS dropped off my flush mounts.

Now I installed my flush mounts testing them the whole way. The mounted great and worked like a charm. After cleaning up the garage I decided to show the new turnsignals to the neighborhood. To my suprise when I turned the bike on and did my short but religious quick inspection...no high beam.

Could I have mees something up or is it a coincidence.
Both lows work fine and my highs worked when I last rode. It was a simple pos & neg hook up. The flush mounts had 3 wire but the package said to use just 2 because that is what was going into the original signals.

Any ideas or should I go get another high?
 

·
Registered
Joined
·
1,606 Posts
Check the easy stuff first. I would pull the bulb and take a look at it. Many times you can see if it is burned out by just looking at the filament. If the filament looks good check it with an ohm meter or continuity tester. Be careful not to touch the glass part of the bulb.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top