Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
527 Posts
Discussion Starter #1
What do you think about a custom chopped header, feeding into a 4-1 collector (3" diameter), with the following valve in it, before it feeds into a 3-4" diameter muffler can? I am curious if it can be wired in to replace the servo motor....



GunRunner
 

·
Registered
Joined
·
527 Posts
Discussion Starter #3
This is going to be a shorty GP style exhaust, but with a tip exiting on each side of the belly...the valve in the image above would be pretty simple to incorporate into the design, as opposed to using the OEM exhaust valve...

GunRunner
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top