Kawasaki Motorcycle Forums banner
1 - 11 of 11 Posts

·
Registered
1992 ZX7J & 2017 z650
Joined
·
136 Posts
Look up "drag bars". They're sometimes straight across, sometimes angled down a bit.

I have clip-ons on my z650 but all the plastic on the front is changed, and I still have a clearance issues with the starter button touching the rectifier.

Clubman bars would probably have clearance issues as well.

If you don't wan't something as drastic as drag bars, Renthal low bars are an option.

Example drag bars:
Fuel tank Vehicle Automotive lighting Automotive tire Motor vehicle
 

·
Registered
Joined
·
413 Posts
I might add that i had clipons, drag bars and all manner of other variations and Ive ended up with low rise bars on my bike. I found clipons too low. the drag bar i had wouldve been ok on a stock triple tree setup but i need it a touch higher on my triple tree.
 

·
Registered
Joined
·
413 Posts
I can’t say for sure. Clip Ons are below the triple tree. Drag bars, will sit level with the stock bar clamp and can be tilted. A cheap drag bar on eBay is 20-30$
sports bars are level with the clamp as well, but can’t tilt
Low rise bars are higher than both those options (lower than stock bars obviously) and can tilt forward
 
1 - 11 of 11 Posts
Top