[Yellow08]

hey guys i am considering taking my header and what not off to gut out my cat, what kind of gaskets are used in between the header and the cylinder head? is it reusable or do i have to buy new ones? thanks in advance guys.

 

[collinjoseph]

Some people replace them, but I have seen them reused before. If you're bike is fairly new (which it is) you can probably get away w/reusing them...

 

[Cydalr]

If you need a part# I believe it's 11060-1330 you need two.

 

[evil skinny]

If you need a part# I believe it's 11060-1330 you need two.

there are 4 copper gaskets used on our 4 cylinder bike. and its part # 11060-1203. you gave him the part # for the gasket that goes after the cat and the one after the uptube the the actual exhaust can slides into. Please be more careful before guessing with part #. I know everyone should double check for themselves but it would majorly suck if someone ordered the wrong part based on what someone said.

 

[Cydalr]

My fault, I was under the impression it was like a car's header gasket. 1 gasket per primary, I just so happen had the a parts list next to me that was faxed over by the shop that's doing repairs for me.