Kawasaki Motorcycle Forums banner
Cancel

Fender Eliminator????

572 Views 1 Reply 2 Participants Last post by  hotbag, 
S
I am going to make my own fender eliminator kit because I have access to aluminum sheeting but I was wondering... Do I have to have an undertail on my 6R for my fender eliminator to work or does that mean that I have to cut the existing rear fender off?

Life is short, but sweet for certain...
Save
Like
Status
Not open for further replies.
1 - 1 of 2 Posts
H
on the new 6r, the whole piece comes off which requires no cutting or drilling. on older models, like yours, you will have to cut that awful piece of plastic off. there is no undertail like the new 6.
good luck!

"I'm from yeranus."
Save
Like
1 - 1 of 2 Posts
Status
Not open for further replies.
Kawasaki Motorcycle Forums
A forum community dedicated to all Kawasaki motorcycles including the ZX-6R, KLR 650, Ninja 250, Ninja 250R, and Vulcan. Come join the discussion about performance, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Two Wheeled Discussion 2003-2004 ZX-6R New Member Introductions Ninja 250R 2007-2008 ZX-6R
Top