Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Just purchased some no-cut polished alum. sliders. Just wondering if they are hard to put on and do I need a torque wrench?
 

·
Registered
Joined
·
561 Posts
Check the how to forum, there is a good guide there, much better than the instructions my sliders came with. The only issue I had was with removing the stock bolts, they were over torqued and I had to get an impact driver to pull them out.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top