[j35skyline]

08 zx6r with Integrated Taillights.
Left signal works correctly.
Right signal when tapped in does not. It just stays on when I connect the wire and does not blink when i try to signal right.

Please help!!! Any advise will be appreciated.

Thanks

 

[murdock1084]

Cross the wires. Put the left on the Right and see if it works. If it does the same thing its the light that has the problem. If it does the same thing its the wiring on the bike.

 

[j35skyline]

Thank you for suggestion. Ive tried crossing all wiring to check but still no luck.

Someone suggested to check the flash relay for the right side?
Perhaps it is not working therefore it just stays on and not blink signalling right..

Does anybody agree?

 

[j35skyline]

anybody had this experience before please help..

 

[Sev]

You hooked it up to the wrong wire.

 

[wmdspalmer]

Try an Ohm meter and see if you are getting voltage. Other wise turn on the signal and tap the relay which may fix it.

 

[tdiv]

... not sure i just wired my stuff in and it works great

 

[ZX6RRNewbie]

Thank you for suggestion. Ive tried crossing all wiring to check but still no luck.

Someone suggested to check the flash relay for the right side?
Perhaps it is not working therefore it just stays on and not blink signalling right..

Does anybody agree?

The flash relay is the same one for the left and right sides.

 

[Sev]

The flash relay is hooked up to the common ground for both turn signals. You likely tapped the right side into the brake light or running light, or didn't make a good connection.

 

[yougoteck]

Do you have OEM flushmount signals for the front? I've read that causes problems for the rear signals sometimes

 

[j35skyline]

I am such a newb!!!!

Previous owner had splice his right signal lights and taped it with black tape but it was disconnected so when I tried to tap to the end wire there was no solid connection.

LOL. Sorry guys.

Appreciate all for helping me solve this.

Smoked integrated Tail lights is now working.

 

[new2dascene]

Sounds like you connected the groud wire to your light instead of the coloured wire.