Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
4,213 Posts
Discussion Starter #1
i was wondring if you had any difficulties bending the seat lock when you installed your undertail. my seat also sits about 1/4 inch too high. i shaved off the tabs on the seat but its still being held up to high by the seat lock retainer. did the hammer you used have a big head(like a sledge) or like a regular construction one? my front seat is a little out of place but its not as noticeable as the back seat.

Member since 8/30/02. Forget what the post count says!
 

·
Registered
Joined
·
4,213 Posts
Discussion Starter #2
well shit this question is for anyone now. i took off a plate that was covering the lock for the back seat. it bent really good, then i installed the plate back over it. installed the seat and now it looks real flush.......

HOWEVER my seat is stuck, i think because i didnt screw in the lock reatiner plate good back into place. how do i go about unlocking my seat? has anyone stuck one of these things before? im thinking of ripping up my rear seat cover, taking the padding off, and try to pry it from over the top.

Member since 8/30/02. Forget what the post count says!
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top