Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
37 Posts
Discussion Starter #1
Hi guys,im from the uk and i have a zx6r 636 2002,i wanna change the turn signals for micro arrows,i can see there is only one wire going from the turn signals to somewhere near the clocks at the front,can i splice the wire to give me 2 wires and then add male and female crimp clips to the wires???,anyone done this and any pictures available so i can see what you did.




"160 mph officer, i have only been out 5 minutes".
 

·
Registered
Joined
·
1,276 Posts
If I remember right... that's just a rubber tube, clit it and inside you'll find 2 wires. Spice in (or connect however you like) your new markers and you'll be fine. It's much easier, and you'll be able to do a nicer & neater job by removing the fairings. Have at it!
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top