Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
4,295 Posts
On my 02, I just drilled through the fairing and used some longer bolts. Solid.
 

·
Registered
Joined
·
297 Posts
I have the same signals, I took the signals apart and drilled a small hole in the center of each and used a small bolt, the used the metel bracket that was on the back side of the stock signals and used two nuts to secure it on. Now if I ever decide to change, no holes in the body...
 

·
Registered
Joined
·
71 Posts
after having installed these same turn signals onto three different bikes [including my own] i have figured out a somewhat easy way to do it. after removing the stock signals, you should be able to cover the hole in the fairing with just enough room to drill small holes on the outsides of the large hole left by the stock signals. just take apart the two screws in the LP lights and you will see two holes you can use to line up your holes in the fairing. then its two simple screws and nuts. Philgood also has a good idea using a bracket to avoid making more holes in your fairing in case you dont like them....but i dont think i will be changing so i went with my way. good luck man.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top