just watched the how to on the kleen air mod and not only is the video fun to watch but very helpful too... anyways it seems really easy i just was wondering was size t valve and hoses were used since it is not stated
Yeah I used half inch. Up until the routing it into the crankcase. Which is 5/8" so just grab a 1/2" T and 1/2" hose then a 1/2" to 5/8" straight piece and use the bit of the hose coming off the crank case to meet the two. Works perfect.
I basically just want to wire a external led off of the existing shift light, make it look clean. I just want it brighter and more visible.
Anyone know where to wire it? Or can i just run wires off the existing light inside the guage cluster?
Some time passed between pulling old motor and swapping in an ebay special replacement and i cant find a home for this connector. The bike runs but bogs above 5k rpm and runs more and more rich as it warms up.
This 2 wire connector is at the end of the harness for the ignition coils.
Need help! Just bought a 2007 zx6r I'm a Honda man but wanted to try something new! Bought it on a rainy night didn't get a good test ride in and when I finally got to drive it for the first time all gears are there definitely has power but starting in first and gassing it.. it seems to lag...
A forum community dedicated to all Kawasaki motorcycles including the ZX-6R, KLR 650, Ninja 250, Ninja 250R, and Vulcan. Come join the discussion about performance, modifications, troubleshooting, maintenance, and more!