Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
151 Posts
Discussion Starter #1
just a quick question... im fabricating a rear fender eliminator and i have some leds im going to be using for turn signals.... i know you need resistors to make them blink slower but my question is this... if i dont use resistors will it make my rear signals blink fast and front blink fast as well??? or will the stock front signals which are not leds stay slow and the back blink fast???? thanks every1
 

·
Registered
Joined
·
343 Posts
no, when you use a relay it only effects the LED signals.
 

·
Registered
Joined
·
1,116 Posts
when I put my rear integrator in it made all the signals blink fast, the front were stock when I put the tail in, then I put the front leds in like 10 minutes later. I got a new flash relay (there are a couple posts on this already) from autozone,under $10. Just replace the relay and don't bother with the freakin resistors just my .02
peace!
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top