Ninja300 2022 model 6 pin OBD pinout needed
2
Hi
to clear engine check light,i need to connect obd reader to the diagnostic connector.The protocol used to communicate via the obd port is kwp2000 / iso9141.So far,what i know is that kawasaki communicates using only three wires of the obd port i.e 12v+,GND & K-Line.
Unfortunately, the Ninja300 2022 model is using 6 pin brand new OBD port like KTM/Suzuki etc.I am attaching pic below of the connector.Can anyone send the pinout??(Which is +12v/GND & the K Line)
![Toy Gesture Finger Thumb Font]()
![Automotive lighting Motor vehicle Guitar accessory Wheel Automotive tire]()
to clear engine check light,i need to connect obd reader to the diagnostic connector.The protocol used to communicate via the obd port is kwp2000 / iso9141.So far,what i know is that kawasaki communicates using only three wires of the obd port i.e 12v+,GND & K-Line.
Unfortunately, the Ninja300 2022 model is using 6 pin brand new OBD port like KTM/Suzuki etc.I am attaching pic below of the connector.Can anyone send the pinout??(Which is +12v/GND & the K Line)
