am looking for a regulator for my rr and am struggling a little to source one
I know I can get one directly from Kawasaki for quite a lot of cash so would rather look aftermarket.
.I know RM stator are out of stock but don't know any other brands that are any good, can you please...
hellou,i wass replacing my all 3 shift forks ,forks rods,and shift drum,and now when is bike on the stand i wass to try to change gears by heand with rear wheel spinning by hand ,but..my bike want to shift only in forst and neutral ??please help the bike is 636 05
I gotta 2005 ninja 636 and I ride for about a hlf hr to hour thn I give it throttle then it completely dies out i let it sit for 5 to 10 min thn starts up an act like nuthn happn thn does it again 20 min latr someone please help me because I'm tired being stranded on side of the road thnk you
I’m stumped and in need of some help!!!!!!!!!
I have a 05 zx6r that I had bought needed a key switch and was a cheaper deal had been sitting outside for a while put a key switch on it does not work found out I bought the wrong one would not allow bike to spark cause stock bike has a resistor in...
So I bought a new gauge cluster for my 03-04 and swapped it out with 05-06 year model gauge. Everything works perfectly except the “MPH”. It’s off by 30mph! Do I need to upgrade the speed sensor or could it be a bad speedometer?
A forum community dedicated to all Kawasaki motorcycles including the ZX-6R, KLR 650, Ninja 250, Ninja 250R, and Vulcan. Come join the discussion about performance, modifications, troubleshooting, maintenance, and more!