Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
ijust installed a slip on on my 2000 zx6r and i feel alittle air squeeze out the connection point. right where the slip on meets the mid pipe...
is there a gasket i can buy or maybe a seal i can get to put between

mike
 

·
Registered
Joined
·
252 Posts
go to PepBoys, AutoZone, etc. and get some high-temp gasket sealer (I used copper, which is extremely high temp, but don't use too much, or it'll leak out and it's very noticeable) -- let it cure and voila!
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
also ... the slip on i got is using allen keys to install... can i get regular screws that have socket tops instead?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top