Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
303 Posts
Discussion Starter #1
I am putting my bike back together today... I am putting the carbs on... the throttle cables are a pain in the ass.... i can't seem to get them connected to that bracket that attatches to the carbs.... Should i tighten the bracket in place then put the cables on or vice versa?? this is frustrating the hell out of me.... its nice today and i wanna ride... could someone explain the entire process of putting the cables on? thanx

yellow = fast
 

·
Registered
Joined
·
70 Posts
When I was going thru this with mine, I had to loosen the bracket, then put the cables ends thru the holes, then put the backet back on. If you are loking for some slack, try using the cable adjusters that are clear up by the throttle to loosen it a bit? Hopefuly that'l get ya goin again if you are not already.

Nazarah, a fully certified intimate apparel bra fit expert.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top