Kawasaki Motorcycle Forums banner

Status
Not open for further replies.
1 - 5 of 5 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
I'm in the middle of my 7500 mile service and I noticed that the lower fitting on the vaccuum valve didn't have a hose connected to it. It doesn't appear this hose is on the bike anymore. The best I could figure out from the manual was that this is supposed to be the "purge" line. Anyone know what's up with this? Do I need to run a new tube or is it fine as is? Where does the other end of the line belong?
 

·
Registered
Joined
·
67 Posts
i took all of that lot out of my bike ya dont need it but on this forum some where there is photos of what to do with the pipes
 

·
Registered
Joined
·
11 Posts
Discussion Starter · #5 ·
So if I ditch this stuff and do the float bowl mod, will I need to change the jets?

The plugs look exactly like they should now and the bike has been running well. I saw another pic and the line that is supposed to be attached there goes down the left inside of the frame toward the seat, but I don't know where from there. anyone know what is supposed to be on the other end of that?
 
1 - 5 of 5 Posts
Status
Not open for further replies.
Top