Kawasaki Motorcycle Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
180 Posts
Discussion Starter #1
I want to cut my Akrapovic bolt-on Titanium down 4 inches. But is there anything I should keep in mind since it's titanium finish? Do I cut the bottom part or top part of the can?
 

·
Registered
Joined
·
786 Posts
I just made my old Yoshi a shorty to sell it. Takes a bit of patience, but I did it from the top.

Not sure how the Akrapovic is made, but from the top was the easiest of the two options.

Putting all the insulation back in was a PITA though
 
1 - 4 of 4 Posts
Top