Hey, what's up guys? I laid my 07 zx6r down a while back and needed to bypass the vehicle down sensor and finally figured out how to do it. And since I did search forever to find a thread on this, and no one has made one, and there are several ppl who need this, I decided to post this. This is for stunters and ppl like me who can't just glue the little internal weight down bc, in my case, there was a short.
This works on 07-08 zx6r and zx14r and most likely zx10r
step1- cut all 3 wires from the connector off the wiring harness (brown, yellow/green, and blue)
step 2- connect both yellow/green and blue with a 1/4 watt 68k ohm resistor
step 3- tape off brown (ground)
AND YOU'RE DONE! SIMPLE AS THAT.
The resistor with lower the voltage down to what the ECU is looking for and bypass your VDS with no effects. BE ADVISED IF U GO DOWN, YOUR BIKE MAY NOT SHUT OFF, being that this is an FI sensor that cuts off fuel in the event of a crash.
This works on 07-08 zx6r and zx14r and most likely zx10r
step1- cut all 3 wires from the connector off the wiring harness (brown, yellow/green, and blue)
step 2- connect both yellow/green and blue with a 1/4 watt 68k ohm resistor
step 3- tape off brown (ground)
AND YOU'RE DONE! SIMPLE AS THAT.
The resistor with lower the voltage down to what the ECU is looking for and bypass your VDS with no effects. BE ADVISED IF U GO DOWN, YOUR BIKE MAY NOT SHUT OFF, being that this is an FI sensor that cuts off fuel in the event of a crash.
